Checking and Adjusting the Basic Settings
To ensure precise cuts, the basic settings of the power tool must be checked and adjusted as necessary after intensive use.
Experience and suitable special tools are required for this.
A Bosch after-sales service point will handle this work quickly and reliably.
- Bring the power tool into the transport position.
- Loosen the locking knob (11) if it is tightened.
- Push the lock button (10) down and turn the saw table (32) to the 0° detent (14).
- Release the lock button (10) again. The saw table must be heard to click into the detent.
- Remove the adjustable fences (18).
Checking (see figure U1)
- Position the set square (55) with the 90° angle flush with the saw blade (46) between the fence (17) and the saw blade on the saw table (32).
The leg of the set square must be flush with the fence along its entire length.
Setting (see figure U2)
- Loosen all hex socket screws (56) with the hex key (27) provided.
- Rotate the fence (17) until the set square is flush along its entire length.
- Retighten the screws.
- Swivel the tool arm slightly to the left to the 0° position and then to the right until you feel it click into place in the 0° position.
Checking
The angle indicators (50) and (52) must be in line with the 0° marks on the scale (51).
Setting
- Undo the screws (57) with a cross-headed screwdriver and align the angle indicators along the respective 0° mark.
- Retighten the screws.
- Bring the power tool into the work position.
- Turn the saw table (32) to the 0° detent (14). The lever must be felt to engage in the detent.
Checking
The angle indicator(13) must be in line with the 0° mark of the scale (33).
Setting
- Loosen the screw (58) using a cross-headed screwdriver and align the angle indicator along the 0° mark.
- Retighten the screw.