Start-up

Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power tool.

Products that are only sold in AUS and NZ: Use a residual current device (RCD) with a nominal residual current of 30 mA or less.

Fold up the safety flap (19).
To start, press the green "on" button ‎(25)‎ .
Drop the safety flap (19) back down.

Press the safety flap (19).

The power tool is equipped with an overload protection system. In normal conditions of use, the power tool cannot be overloaded. In the event of overloading, the power tool automatically shuts off the electronics.

Follow these steps to restart the power tool:

Allow the power tool to cool down for at least ten minutes.
Press the restart button (26) and then switch the power tool back on.

The on/off switch acts as a zero-voltage switch that prevents the power tool from starting up again following a power outage (e.g. if the mains plug is removed during operation).
To restart the power tool following a power outage, press the green "on" button (25) again.

Start-up

Switching on (see figure F1)

Switching off (see figure F2)

Overload protection

Power outage